لوگو-کی-پلاس - Kplus Logo

Polished Polymer Plaster (Skimlite)

Gypsum plaster with modified surface hardness.

 

Properties and added value

■ Smooth surfaces for fine finishing
■ Easy and fast application
■ High adherence quality
■ Extended application duration
■ A1 class material (non combustible)

Safety Instructions

■ Wash hands with plenty of water after handling.
■ Use protective gloves / protective clothing / eye protection / face protection.
■ In case of contact with eyes: Rinse your eyes cautiously with water for several minutes. If there is a lens remove it and continue to rinse.
■ If eye irritation persists: Get medical advice / attention.

Product description

Hand applied gypsum finishing plaster for interior applications.
Storage
The bags should be stored horizontally on a flat surface such as a wooden pallet and kept dry so that they do not come into contact with water. Partly opened and / or damaged bags should not be used. Product shelf time is 6 months.
Standards referred to
ISIRI12015-1 and EN 13279- 1 category C6/20/2
Field of application
Hand applied gypsum plaster as a final coat of surface finish
for interior applications. It is used to obtain a smooth and
even surface before the application of wall finishing such as paint and wall paper. If the thickness over than 1 mm is needed, it should be applied as two or three layers amount 1mm of each layer.

Application

■ Clean the surface and repair if necessary.
■ Pour the plaster into the water in a clean container according to the appropriate mixture ratio until it exceeds the water surface for one finger. After waiting for 2-3 minutes, mix at low speed with a mechanical mixer until achieving a good mixture.
■ Let the mixture rest for another 2 minutes, and then stir again.
■ Do not add water and gypsum to the pulped mortar.
■ This product should be applied as a thin layer with a thickness of maximum 1 mm on the surface with trowel.

Trowel, putty knife, etc.

Do not apply below +5°C ambient, material and / or floor temperature.
Fresh mortar should be protected against frost and quick drying.

■ 90-110 minutes acc. to substrate

Technical specifications

Packaging

It is suggested to follow the technical details which given on Kplus system brochures for application.